![]() ![]() In my opinion this tool is the worst ( i told you this by PM too )Īnd you need to connect it to the USB and to the car if you wanna do an interface test Then it has no GAL/ATF and no power supply regulator 7805 This will be imposible to flash it if you'll erase it Hi guys, i received my lead today but the disk was damaged that has the software on it.not a great start at all.i have attached photos, can anyone help with the correct software as i am now worried i will download the wrong could you please check if i have bad clone unit for me buddy,looks like i have same one everyone has problems withįirst of all as i see this tool it hasn't Atmega MCU I searched in all possible places to find a solution to repair my VCDS 12.12.0 interface but no succes !ĭoes anyone have a solution or I should throw it away ? I know that i have problems with the firmware from controller. Has been recognized as Ross-Tech interface, but VAG-COM says that is not connected to the car. I have an VCDS 12.12.0 interface with FT232RL, ATMEGA162V, MCP2551, MCP2515 without GAL/ATF which is not working. You can try with the ept file that has the VID/PID 0403/FA24 or you can change it with VID/PID 0403/FA30 The ept file for FTDI232RL in chinese tools it is allmost the same
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |